DALBO MAXICUT 920, Manual, Page: 27 / 49

MAXICUT
Page 27
Installation
When replacing drums, a crane, truck or similar lifting equipment will be required.
It is recommended that the drums be emptied of any water before disassembly. This is done
both to facilitate the handling of the drums after disassembly, but also to secure them
against frost. This applies both to the smooth grass drums and the knife drums.
Before folding, ensure that no person is positioned near the machine.
All maintenance and repair work on MAXICUT must be conducted only when the ma-
chine is lowered to the ground or, is set in transport mode, the tractor break is set,
the engine is switched off and the ignition key is removed, so that the machine can-
not move or start accidentally.
Fig. 13
1. When changing the drums, the machine must be folded and lowered to the ground. The
drums/machines can be used to lower the pallets to make them easier to handle when
disassembled.
2. When all sections are on the ground, loosen bolts A and nuts B on all the bearings to re-
lease the containers.
3. The machine is lifted up onto the timing belt and the 3 containers can now be removed.
4. When the new containers are to be installed, use the same procedure.
a. One can also install them with the help of a crane
5. It is easiest to install the centre container first and then the 2 sides.
6. The supplied scrapers for the smooth drums are bolted onto the machine approx. 10 mm
from the drum.

It is important to "disassemble" the smooth drum scrapers when reinstalling knife
drums.

If the drums are stored somewhere with the possibility of frost, it is important
that they are emptied of water. This must be done to secure the drums against
frost. Damages incurred due to frost are not covered by the warranty.
Mole planks
B
A