DALBO MAXICUT 920, Manual, Page: 16 / 49

MAXICUT
Page 16
Settings
MAXICUT is incredibly easy to work with. The machine's design makes it very easy to set.
It is always necessary to check the incline of the frame before use to ensure optimum use of
the machine.
Tensile adjustment
To achieve uniform cutting of crops and unnecessary load of the machine, the main frame
should be horizontal or slightly tilted over the ground surface. The main frame and knife
drums will then also be horizontal in relation to each other.
Fig. 4
Here you can see the MAXICUT 920 at
work. The main frame is horizontal
while the individual knife sections
have the opportunity to move.
Properly adjusted feature results in a uniform packing/cultivation of the field, as the drum
will pack evenly on each of the 3 sections. The 3 knife sections are pendulum suspended and
can move in relation to the slope of the ground.
Fig. 5

An incorrectly installed feature can cause unnecessary load to the machine and
lead to a breakdown. In particular, a pull installed too high (the main frame is tilted
backwards), as this places a lot of weight on the middle knife section.

It is important to make sure that the main frame is horizontal or slanting a little
forward.
If the pull leans backwards, the tractor's lift arm is too far up. If the pull leans forwards, the
tractor's lift arm should be raised.
HORIZONTAL