DALBO MAXICUT 920, Manual, Page: 25 / 49

MAXICUT
Page 25
0. Verify that the sections are completely lowered and the machine is unfolded and lowered
to the ground.
1. Pressure is put on the plates, after which the lever is put into float position.
If the machine is raised up on the timing belt during turning as recommended, the plates are
lifted off the ground and one doesn't need to do anything else. If one turns sharply or does
not raise the machine on to the timing belt during turning, then one must raise the wave
plates before turning.
2.
When turning or in sharp curves, the wave plates are lifted off the ground by the hydrau-
lics.
3. Pressure is put on the plates, after which the lever is put into float position.

EXTREMELY IMPORTANT: The plate sections must be fully lowered before being
folded with the machine. Otherwise the machine and the plates could be damaged.
Retrofitting
The plates can be installed at the factory, but it can also be delivered later if the need arises.
For retrofitting, a crane, truck or similar auxiliary equipment will be required.
When ordering plates for retrofitting, installation instructions will be provided for assembly
of plate sections and hydraulics.
It is important to ventilate the system thoroughly after installation, in order to pre-
vent personal injury. Therefore, the depth adjusting cylinders are fully moved into
the outer positions a few times.

It must be verified that the plates are sufficiently tight and not loose on the shaft
before starting.