DALBO MAXICUT 920, Manual, Page: 21 / 49

MAXICUT
Page 21
Turning in the field or headland
When one turns in the headlands and fails to raise the machine up on the timing belt, it is
important to jump 1 to 2 pulls over. That means one must drive in every second or third pull
to protect the machine and, in particular, bearings and rubber dampers.
It is recommended driving in every third pull if one fails to raise the machine in the
headlands.

It is important to jump 1 to 2 pulls over so as not to damage bearings and rubber
dampers.
Driving speed
It is recommended that the machine be driven at 15 – 20 km/h, but driving should always be
done according to conditions.
If the speed is increased, wear will also increase, especially under dry conditions. At the same
time, there is a danger that the knife drum will start throwing soil material and rocks.
Power
The power requirement is very dependent on the type of soil and terrain as well as the speed.
Guide for power requirements in HP
Model
Standard machine
920
Machine with the plate
equipment installed
HP min.
300 350 – 400