Daikin VRV II Series, Design, Installation & Testing Instructions, Page: 217 / 242

Si39-303 Operation Procedure
Operation Manual 211
6.4 Programming Start and Stop of the System with Timer
!
The timer is operated in the following two ways.
Programming the stop time “
”. The system stops operating after the set time has
elapsed.
Programming the start time “
”. The system starts operating after the set time has
elapsed.
!
The timer can be programmed for a maximum of 72 hours.
!
The start and the stop time can be simultaneously programmed.
RXYQ series REYQ series
Press the timer mode start/stop button several times and select the mode on the display.
The display flashes.
• For setting the timer stop “
”
• For setting the timer start “ ”
Press the programming time button and set the time for stopping or starting the system.
Each time this button is pressed, the time advances or goes backward by 1 hour.
Press the timer on/off button.
The timer setting procedure ends. The display “
” or “ ” changes from
flashing light to constant light.
Notes:
!
When setting the timer off and on at the same time, repeat the above procedure (from “ ”
to “ ”) once again.
!
After the timer is programmed, the display shows the remaining time.
!
Press the timer on/off button once again to cancel programming. The display vanishes.
For example:
When the timer is programmed to stop the system after 3 hours and start the system after 4
hours, the system will stop after 3 hours and start 1 hour later.
RXYQ series REYQ series
1
2
3
1
3