91
ENG
pRack PR300T +0300018EN rel. 1.5 - 02.05.2017
Example: The following fi le will upload the BIOS and an application.
[FUNCTION]
Upload application
[DIR]
NEW AHU
[NAM]
BIOS+APPL+LOGSv58B36
bisn509.bin
[IUP]
AHU_EN.iup
AHU_IT.iup
[BIN]
AHU.blb
[DEV]
AHU.dev
[GRP]
AHU.grp
[PVT]
AHU.pvt
[LCT]
AHU.lct
10.3.3 Automatic
upload
To automatically upload the parameter memory using the fi
rst
confi guration fi le shown in the preceding paragraph, access the system
menu as previously described and proceed as follows:
1.
Select automatic mode. A screen is shown describing the function
of the buttons. Press Enter to confi rm.
4ELECTUPLOADMODE
"650."5*$.0%&
."/6"-.0%&
Fig. 10.o
2. Confi
rm by selecting Prg. A screen is displayed requesting
confi rmation to upload the non-volatile memory. Press Enter to
confi rm.
61-'*-&?%&7
Fig. 10.p
3.
At the end a message will ask the user to remove the pendrive.
61-0"%*/('*-&
1-&"4&8"*5
Fig. 10.q
10.3.4 Upload in autorun mode
Uploading in autorun mode is a special case of uploading in automatic
mode. Unlike automatic mode, the user must wait for a specifi c message
to appear on the display to start or disable the operation described in
the confi guration fi le. To upload a fi le in autorun mode, a confi guration
fi le must be created and named “autorun.txt”. Example of uploading
BIOS+application. The upload involves two steps: fi rst the BIOS is updated
and then the application. The information is shown on the pRack’s built-
in display and on the pGDE terminal, when both are featured.
Procedure:
1.
Connect the pendrive to port A.
USB
key
2.
After a few seconds, Autorun mode starts. Press Enter to confi rm.
"65036/.0%&
61-0"%"11-*"5*0/
1RESS&/5&3TOSTART
&4$TOEXITAUTORUN
Fig. 10.r
3.
The validity of the FW is checked and the BIOS is loaded.
'8VALIDATION
1LEASEWAIT
Fig. 10.s
4.
The display fl ashes to indicate that after loading the new BIOS the
controller is being reset.
'8WBMJEBUJPO
1MFBTFXBJU
Fig. 10.t
NO LINK
pGD
Fig. 10.u
5.
The test phase starts.
"PPLICATIONPROGRAM
CORRUPTEDORNOT
PRESENT
8"*5*/(FORUPGRADE
Fig. 10.v
Page 140 of 172
Copyright HPL March 2021
P4114S Rev 03
Summary of Contents for Hubbard GCU2040PXB1
Page 4: ...Page 4 of 172 Copyright HPL March 2021 P4114S Rev 03...
Page 49: ...6 Carel PR300T CO2 Controller manual Page 49 of 172 Copyright HPL March 2021 P4114S Rev 03...
Page 144: ...Page 144 of 172 Copyright HPL March 2021 P4114S Rev 03...
Page 165: ...9 Commissioning Form Page 165 of 172 Copyright HPL March 2021 P4114S Rev 03...
