Commissioning Manual EM11A021
DCM601A51 intelligent Touch Manager
58
4-10 Installation
Data installation to the iTM unit includes installation of upgrade data and pre-engineered data (See
4-7 Pre-engineering). The installation procedure is the same in all cases.
The following describes the operating procedure.
1. Insert the USB memory with the target data into the iTM unit and turn on, or restart, the iTM unit
while pressing the MONITOR button provided on it. Keep the MONITOR button depressed until
the following screen appears and then release it. To restart, press the RESET// switch on the
front panel. (See the intelligent Touch Manager Installation Manual).
2. The calibration screen appears. Correct the touch panel calibration. To calibrate more accurately,
use a touch pen.
(1)
3. A cross
(1)
will appear 5 times on the screen. Touch the centre of each cross in order. You can
start the calibration again by touching a point far from the cross. The calibration is complete
when you touched the cross 5 times.
Summary of Contents for DCM601A51
Page 125: ...EM11A021 1208 HT...