Dahua ARC6416C series, User Manual

Page: 80 / 117

Figure 6-38
Step 2. Set parameter, see Chart 6-16.
Parameter Note
Enable Check and select the channel number for which you want to enable motion
detection.
Period Set the arm and disarm time, in the set time range linkage of the corresponding
configuration item to start the alarm, see Ch 6.3.1.1.1.
Anti-dither Only one motion detection event is recorded during the Anti-dither time period.
Sensitivity The greater the sensitivity value, the easier it is to trigger the motion check, but at
the same time increase the false alarm rate, it is recommended to use the default
value.
Region To set the range of motion detection, see Section 6.3.1.1.2.
Record
Channel When motion detection alarm occurs, the system will record the selected channel
(support check).
Note
 Record file storage path can refer to Ch 6.1.2.4.
 To trigger motion detection, the system also need to meet the following two
conditions:
The video recording has been turned on. For details, refer to Ch 6.4.2.1.
Auto recording has been set. For details, refer to Ch 6.4.2.2.
Delay After the motion detection alarm finished, the time for resumed recording.
Alarm Out The alarm output ports connect alarm devices (such as lights, sirens, etc.), when
motion detection triggered, system will sent alarm information to these alarm
devices.
Latch After the motion detection alarm, continue to alarm for some time.
PTZ
Activation When a motion detection alarm occurs, the video monitoring screen is linked to the
corresponding pan / tilt action. For details, refer to Ch 6.3.1.1.3.
Note:
Motion detection only supports linkage to the preset point.
Snapshot When a motion detection alarm occurs,
trigger selected channel’s snapshot.
Note:
 The snapshot has been opened. For details, refer to Ch 6.4.1.
 For the storage location query and setting, please refer to Ch 6.1.2.4.
Voice
Prompt When a motion detection alarm occurs, the selected voice file is played back.
Note:
The selected voice file must be added to the voice management file list. For details,
refer to Ch 6.5.2.
Send
EMAIL When the motion detection alarm occurs, send an e-mail to the set mailbox to
inform the alarm.
Note:
Required setup of Email, see Ch 6.2.8.