Dahua ARC6416C series, User Manual

Page: 71 / 117

Parameter Note
Three Times to
Reboot
Three times to reboot function, is to improve the efficiency of base
stations to solve the problem of wireless information networking and
field surveillance unit off-line fault caused by its own hardware and
software problems.
When checked, Surveillance Unit will reboot if VPN dialing fails.
Note:
In case of wired network, three times to reboot function is invalid.
Wireless
Network Check, the device will dial to the external network through 3G / 4G
module and VPN dial-up.
Type VPN1 is the primary connection VPN, VPN2, VPN3, and VPN4 are
standby connections. Configure the active and standby VPNs
according to the actual situation. When VPN dials in, it will dial to
the primary VPN server first, and if it fails, it will change to dialing to
the standby VPN server.
Connection
Name For customization.
WLAN Type Support PPTP and L2TP VPN technology.
PPTP: A point-to-point tunneling protocol that encapsulates and
encrypts IP, IPX, and NetBEUI communications using Point-to-
Point Protocol (PPP) user authentication and Microsoft Point-
to-Point Encryption (MPPE).
L2PT: Layer 2 tunneling protocol that encapsulates and encrypts IP,
IPX, and NetBEUI traffic using PPP user authentication and IP
security (IPSec) encryption.
Server IP
VPN server
’s IP address, username and password.
Username
Password
Identification The following authentication methods are supported:
PAP: Common password authentication protocol
EAP: Extended Authentication Protocol
CHAP: Challenge Handshake Authentication Protocol
MSCHAP: The Microsoft version of CHAP, which provides two-way
authentication
MSCHAPV2: The Microsoft version of CHAP Version 2, providing
two-way authentication and a more robust initial data key
MPPE: Microsoft's point-to-point encryption technology, to achieve
the confidentiality of the data link layer protection
MPPE Security After checking, MPPE encryption is enabled. In this case, you can
set the number of encryption bits and whether or not status
encryption is available.
Allow Compress
BSD After checking, the data will be compressed and transmitted by the
BSD algorithm.
Allow Compress
Deflate After checking, the data will be compressed and transmitted via the
Deflate algorithm.
Chart 6-13
Step 3. Click OK.
Step 4. Place mouse on at the upper right corner, see connection status.
6.2.13 Register