Step 4. Double click WIFI to connect. Click Refresh to get connection status.
6.2.4
4G
Warning:
Ensure connection with 3G/4G module.
The device accesses the 3G / 4G network through the dial-up mode of each operator, and
realizes the functions such as receiving alarm information, device state, audio / video, image
receiving and so on.
Select Setup>Network>4G>4G Set, see Figure 6-15.
Figure 6-15
If the dialing is unsuccessful or frequently dropped, make sure that the 4G module, USB cable
and antenna are connected correctly and that the signal strength is above -90dBm.
Note:
You can place mouse on
at the upper-right corner to view 4G connection status.
6.2.5
PPPoE
By enabling PPPoE (Point-to-Point Protocol over Ethernet) dial-up connection, the device will
obtain a dynamic IP address for the WAN. Before doing so, obtain the PPPoE user name and
password provided by the ISP (Internet Service Provider).
Note:
After enabling PPPoE function, select Setup>Network>TCP/IP, you cannot edit IP address here.
Step 1. Select Setup>Network>PPPoP. See Figure 6-16.
Figure 6-16
Step 2. Check Enable, enter PPPoE username and password.
Summary of Contents for ARC6416C series
Page 1: ...1 Video Field Surveillance Unit User s Manual V 1 0 0 For ARC6416C series...
Page 8: ...Figure 1 1...
Page 23: ...Figure 4 5 4 3 3 Add Peripheral Protocol Step 1 Click 3 Protocol Management see Figure 4 6...
Page 105: ...Figure 7 3 Click to view detailed alarm of each peripheral see Figure 7 4 Figure 7 4...