45
5.11.4 Communication
You can search controller IP address, subnet mask, gateway, port and RS485 address.
Operation method: enter [code command] + [OK] +[administrator/operator password]
Search IP address, subnet mask, gateway and port no. commands are shown below.
①
1
②
1
No.
Note
①
Code address, means this operation is to search IP
address, subnet mask, gateway and port.
②
Search content
：
1
－
IP address
，
2
－
subnet mask
，
3
－
gateway
，
4
－
port.
Code command to search RS485 address: enter number
【
2
】
.
5.11.5 Host Status
You can view each module status in alarm controller.
Operation method: [OK].
Result is shown below.
Note:
When check box is black, it means corresponding module has error. When check box is empty, it
means corresponding module is normal.
5.11.6 Output
You can search controller siren status and output stauts.
Operation method: enter [code command] + [OK].
Search siren status code command: enter number key
【
1
】
.
Code command to search output status is shown below.
2 001
①
②
No.
Note
①
Code address, means this operation is to search alarm
output status of a certain zone, default is 2.
