17
4.1.2.2
Disarm
You can disarm arming of alarm controller.
Step 1. Select SETUP>Zone Management>Arm/Disarm Zone.
Step 2. Set zone type to Global Arm, click OK. Confirmation box pops up.
Step 3. Input username and password, confirm. Device has two tone prompt as successfully
disarmed.
4.1.3 Alarm Program Keypad Arm/Disarm
Please refer to Alarm Programming Keypad User’s Manual for wired programming keypad.
Wireless alarm programming keypad is in Ch 5.4 and 5.5.
4.1.3.3
Arm
General Arm
Via keypad, arm the zone, alarm controller will response alarm signal in the zone.
Step 1. Press
key, to next level menu.
Step 2. By pressing
or
, select arm/disarm, press
.
Step 3. By pressing
or
, select arm, press
.
Step 4. Input arm type no., press
key.
Note:
1
Global arm
2
Instant arm
3
Out arm
4
Home Arm
5
Force to arm
Step 5. Input main user password, press
key.
If successfully arm, device buzzer has tone prompt, and enter exit delay status, according to
set exit dekay, buzzer once per 1s, and buzzer twice per 1s for last 10s. If failed, then dvice will
buzzer three times continuously. Now you shall check whether there is zone input, and you can
force to arm.
Quick Arm
In keypad homepage, input user password, device has tone prompt, and enter exit delay status,
according to set exit dekay, buzzer once per 1s, and buzzer twice per 1s for last 10s. If failed,
then dvice will buzzer three times continuously. Now you shall check whether there is zone input,
and you can force to arm.
Note:
Quick arm will only arm globally.
4.1.3.4
Disarm
General Disarm
Step 1. Press
key, to next level menu.
