19
Figure 4- 3
Add Wireless Remote Control
Click Enter Code Match, and press any key on wireless remote control.If successfully matched,
then WEB page will show wireless device info. See
After successfully matched, you can modify and delete wireless remote control info.
M odify wireless remote control info:
Click
, pop up parameter window.
Parameter Note
Enable
Select enable, the device can arm/disarm and alarm.
Mode
As normal and patrol. Normal is for arming/disarming and alarm; patrol is
for remote control patrol function, report to platform.
Username Remote control name.
Delete wireless device:
Click
, and confirm, delete the wireless remote control from system, as you cannot
arm/disarm or alarm.
Add Wireless Remote Sensor
Click Enter Code Match, and plug sensor to power, after indicator NO, dial vandal -proot switch,
indicator starts to flash. Wait about 10s, if indicator turns OFF, it means that matching is
successful. If indicator slowly flashes three times, it means that matching failed, and you shall
follow above steps again to connect.
Note:
Sensor code match is available for models of ARC5408B-W, ARC5408B-CW, ARC5408B-EW
and etc.
4.3 Zone Config
Set zone parameters, zone delay for each zone.
4.3.1 Zone Parameter Config
