Web Configuration 66
Parameter
Description
Pulse Width
Configure the pulse width of flash lamp. The higher the value, the
brighter the light.
Delay Time
Configure the delay time of the light to keep the snapshot in sync
with the flash.
Burst Mode
You can select the level that activates the flashing light. Currently,
only Low level is supported.
Frequency
Lamp
Output
Mode
Forbidden: The light is normally off.
Always: The light is normally on.
Default: Configure the Prevalue of brightness. When the
actual brightness is lower than this value, the light automatically
turns on.
Delay Time
Configure the delay time of the light to keep the snapshot in sync
with the flash.
Pulse Width
Configure the pulse width of the light. The higher the value, the
brighter the light.
Freq
Configure the flash frequency of the light. The higher the value,
the more frequent the light flashes.
Prevalue
Prevalue of brightness. You can drag the slider to adjust the
value. The higher the value, the brighter the light.
6.5.1.8.3 Power Config
The Camera can ouput DC12V power when the power switch is on.
Select
Setting > ITC > Extra Device > Power Config
, the
Power Config
interface is
Step 1
displayed. See Figure 6-71.
Check
Switch On
, and the camera can supply DC12V power.
Step 2
Click
OK
to save the configuration. Click
Refresh
to refresh the interface. Click
Default
Step 3
and then
OK
to restore to default settings.
Power config
Figure 6-71
6.5.1.8.4 Anti-fog Function
You can enable anti-fog function if there is any droplet that may condense on the surface of
glasses and influence the quality of captured images.
