Daedong Kioti LK30, Workshop Manual

Page: 35 / 326

1-19 SS41-W00 May. 2007
LK30
CLUTCHCLUTCHCLUTCHCLUTCHCLUTCH
ENGINEENGINEENGINEENGINEENGINE
TRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSION
FRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLE
STEERINGSTEERINGSTEERINGSTEERINGSTEERING
BARKEBARKEBARKEBARKEBARKE
ELECTRICELECTRICELECTRICELECTRICELECTRIC
INDEXINDEXINDEXINDEXINDEX
HYDRAULICHYDRAULICHYDRAULICHYDRAULICHYDRAULIC
GENERALGENERALGENERALGENERALGENERAL
REAR AXLEREAR AXLEREAR AXLEREAR AXLEREAR AXLE
1
1
6. After the new filter has been replaced, fill with oil up
to the upper line of the gauge.
7. After running the engine for a few minutes, stop it
and check the oil level again, add oil to the pre-
scribed level.
8. Make sure that the transmission fluid doesn’t leak
through the seal.
(1) Hydraulic oil filter
3. Remove the oil filter.
4. Put a film of clean transmission oil on the rubber
seal of the new filter.
5. Tighten the filter quickly until it contacts the mount-
ing surface.
Tighten the filter by hand an additional half turn only.
(1) Gauge
(2) Oil inlet plug
(A) Oil level is acceptable within this range
265W135A
265W134B
•
To prevent serious damage to the hydraulic
system, use only a KIOTI genuine filter.
IMPORTANT
(1) Drain plugs
1. Remove the drain plug at the bottom of the trans-
mission case and drain the oil completely into the
oil pan.
2. After draining reinstall the drain plug.
265W133B
8.2.9 REPLACING HYDRAULIC OIL FILTER
To avoid personal injury:
• Be sure to stop the engine before changing the oil
filter.
• Allow engine to cool down sufficiently, oil can be
hot and can burn.
CAUTION
GENERAL - CHECK AND MAINTENANCE
Lk30_01_general.p65
2007-07-26, ¿ÀÈÄ 12:03 Page 19
Adobe PageMaker 6.5K/Win