Daedong Kioti LK30, Workshop Manual, Page: 121 / 326

2-69 SS41-W00 May. 2007
LK30
CLUTCHCLUTCHCLUTCHCLUTCHCLUTCH
ENGINEENGINEENGINEENGINEENGINE
TRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSION
FRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLE
STEERINGSTEERINGSTEERINGSTEERINGSTEERING
BARKEBARKEBARKEBARKEBARKE
ELECTRICELECTRICELECTRICELECTRICELECTRIC
INDEXINDEXINDEXINDEXINDEX
HYDRAULICHYDRAULICHYDRAULICHYDRAULICHYDRAULIC
GENERALGENERALGENERALGENERALGENERAL
REAR AXLEREAR AXLEREAR AXLEREAR AXLEREAR AXLE
11
10
9
265W257A
7.3.2 ROCKER ARM BUSHING AND
SHAFT CLEARANCE
1. Measure the rocker arm I.D. with an inside micrometer.
2. Measure the rocker arm shaft O.D. with an outside
micrometer.
3. If the clearance exceeds the allowable limit, replace
the rocker arm.
4. If the clearance still exceeds the allowable limit after
replacing the rocker arm replace the rocker arm shaft.
Allowable limit
0.15 mm
0.0059 in.
-
-
0.014 ~ 0.050 mm
0.00055 ~ 0.00197 in.
13.973 ~ 13.984 mm
0.5501 ~ 0.5506 in.
13.998 ~ 14.023 mm
0.5513 ~ 0.5529 in.
Clearace
Rocker arm
haft O.D.
Rocker arm I.D.
Item Factory spec.
265W258A
7.3.3 TIMING GEARS AND CAMSHAFTS
A. TIMING GEAR BACKLASH
1. Set a dial indicator (lever type) with its tip on the
gear tooth.
2. Move the gear to measure the backlash, holding its
mating gear.
3. If the backlash exceeds the allowable limit, check
the oil clearance of the shafts and the gear.
4. If the oil clearance is improper, replace the gear.
Allowable limit
0.15 mm
0.0059 in.
0.04 ~ 0.11 mm
0.0016 ~ 0.0043 in.
Clearance
Item Factory spec.
ENGINE - SERVICING
Lk30_02_engine(41-82).p65
2007-07-26, ¿ÀÈÄ 12:04 Page 69
Adobe PageMaker 6.5K/Win