Daedong Kioti LK30, Workshop Manual, Page: 266 / 326

9-6 SS41-W00 May. 2007
LK30
CLUTCHCLUTCHCLUTCHCLUTCHCLUTCH
ENGINEENGINEENGINEENGINEENGINE
TRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSION
FRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLE
STEERINGSTEERINGSTEERINGSTEERINGSTEERING
BARKEBARKEBARKEBARKEBARKE
ELECTRICELECTRICELECTRICELECTRICELECTRIC
INDEXINDEXINDEXINDEXINDEX
HYDRAULICHYDRAULICHYDRAULICHYDRAULICHYDRAULIC
GENERALGENERALGENERALGENERALGENERAL
REAR AXLEREAR AXLEREAR AXLEREAR AXLEREAR AXLE
2.4.2 FUNCTION AND OPERATION
A. FUNCTION
It filters any particle or contaminated substances.
B. OPERATION PRINCIPLE
The filtering system as of an inlet filter installed on the
inlet gear pump is composed of filter bracket and ele-
ment assembly.
The filter used for CK series tractors is applicable to both
hydraulic lift and steering wheel direction control circuits.
The hydraulic oil flows into the IN port of the filter
bracket. The transmission oil is delivered into the hy-
draulic element assembly (3) and delivered out through
the outlet port to the hydraulic pump. All foreign sub-
stances are filtered by the element at this time.
C. TO CHECK
The hydraulic filter shall be replaced every service term
of 200 hours.
(1) Filter bracket
(2) Hydraulic filter
(3) Hydraulic element assembly
704W903A
2.4 OIL FILTER
2.4.1 STRUCTURE OF OIL FILTER
The suction filter (1) is a canister-type filter and should
be replace after 200 hour of use.
There is a permanent magnet installed on the center
of the element of the hydraulic filter on the inlet hydrau-
lic pump and the filter mounted on the hydraulic lift is
structured.
(1) Hydraulic filter (2) Filter bracket
704W902A
265W905A
HYDRAULIC SYSTEM - OPERATING PRINCIPLE
Lk30_09_hydraulic.p65
2007-07-26, ¿ÀÈÄ 12:06 Page 6
Adobe PageMaker 6.5K/Win