xStack
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Sw itch
300
From / To
Select ports to be initialized.
MAC Address
The MAC address of the Switch connected to the corresponding port, if any.
Port
A read-only field indicating a port on the Switch.
Auth PAE State
The Authenticator PAE State will display one of the following: Initialize, Disconnected,
Connecting, Authenticating, Authenticated, Aborting, Held, ForceAuth, ForceUnauth, and N/A
.
Backend State
The Backend Authentication State will display one of the following: Request, Response,
Success, Fail, Timeout, Idle, Initialize, and N/A.
Port Status
The status of the controlled port can be
Authorized, Unauthorized,
or
N/A.
Click
Apply
to implement the changes.
NOTE:
The user must first globally enable 802.1X in the
DGS-3400 Web
Management Tool
window before initializing ports. Information in the
Initialize Ports Table cannot be viewed before enabling 802.1X.
Reauthenticate Port(s)
This window allows reauthentication of a port or group of ports by using the pull-down menus
From and To and clicking
Apply
.
The Reauthenticate Port Table
displays the current status of the reauthenticated port(s) once
Apply
has been clicked
.
To view this window, click
Security > 802.1X > Reauthenticate Port(s)
, as shown below.
Figure 6 - 31 Reauthenticate Port window (Port-based 802.1X)
NOTE:
The user must first globally enable 802.1X in the
DGS-3400 Web
Management Tool
window before initializing ports. Information in the
Initialize Ports Table cannot be viewed before enabling 802.1X.
To reauthenticate ports for the MAC side of 802.1X, the user must first enable 802.1X by MAC address in the
DGS-3600 Web
Management Tool
window.
Click
Security > 802.1X > Reauthenticate Port(s)
, as shown below.
