3.70. L2TPServer
Description
A PPTP/L2TP server interface terminates PPP (Point to Point Protocol) tunnels set up over existing
IP networks.
Properties
Name
Specifies a symbolic name for the interface.
(Identifier)
IP
The IP address of the PPTP/L2TP server interface.
TunnelProtocol
Specifies if PPTP or L2TP should be used for this
tunnel. (Default: PPTP)
Interface
The interface that the PPTP/L2TP Server should be
listening on.
ServerIP
Specifies the IP that the PPTP/L2TP server should
listen on, this can be an IP of a interface, or for
example an ARP published IP.
UseUserAuth
Enable the use of user authentication rules on this
server. (Default: Yes)
MPPENone
Allow no authentication for this tunnel. (Default:
Yes)
MPPERC440
Use an RC4 40 bit MPPE session key with MS-CHAP
or MS-CHAP v2 authentication protocol. (Default:
Yes)
MPPERC456
Use an RC4 56 bit MPPE session key with MS-CHAP
or MS-CHAP v2 authentication protocol. (Default:
Yes)
MPPERC4128
Use an RC4 128 bit MPPE session key with
MS-CHAP or MS-CHAP v2 authentication protocol.
(Default: Yes)
IPPool
A range, group or network that the PPTP/L2TP
server will use as IP address pool to give out IP
addresses to the clients from.
DNS1
IP of the primary DNS server. (Optional)
DNS2
IP of the secondary DNS server. (Optional)
NBNS1
IP of the primary Windows Internet Name Service
(WINS)
server
that
is
used
in
Microsoft
environments which uses the NetBIOS Name
Servers (NBNS) to assign IP addresses to NetBIOS
names. (Optional)
NBNS2
IP of the primary Windows Internet Name Service
(WINS)
server
that
is
used
in
Microsoft
environments which uses the NetBIOS Name
Chapter 3: Configuration Reference
229
Summary of Contents for NetDefend DFL-260E
Page 21: ...Chapter 1 Introduction 21...
Page 104: ...Chapter 2 Command Reference 104...
Page 240: ...Comments Text describing the current object Optional Chapter 3 Configuration Reference 240...
Page 317: ...Comments Text describing the current object Optional Chapter 3 Configuration Reference 317...
