DES-3000 Series Layer 2 Switch CLI Reference Manual
DES-3026:4#show bandwidth_control 1-12
Command: show bandwidth_control 1-12
Bandwidth Control Table
Port RX Rate (kbit/sec) TX_RATE (kbit/sec)
---- ------------------------ ----------------------
1 100000 100000
2 100000 100000
3 100000 100000
4 100000 100000
5 100000 100000
6 100000 100000
7 100000 100000
8 100000 100000
9 100000 100000
10 100000 100000
11 no_limit no_limit
12 no_limit no_limit
DES-3026:4#
config cos port_mapping
Purpose
Used to map a specific port to one of the hardware queues available on the
Switch.
Syntax
config cos port_mapping [class <class_id 0 | 3>] [<portlist> | all ]
Description
Use this command to configure port-to-class CoS mapping. Port mapping
must first be enabled using the command
config cos mapping port
<portlist> port_mapping
on the ports before this can be configured.
Parameters
class [0 | 3]
−
Specifies to which of the Switch’s hardware priority classes of
service value will be mapped for the port or ports. There are two classes
available for port COS mapping.
<portlist>
−
Specifies a port or range of ports to be configured.
all
−
Specifies that the mapping will be applied to all ports on the Switch.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To configure CoS port mapping for a range of ports:
DES-3026:4#config cos port_mapping class 0 1-4
Command: config cos port_mapping class 0 1-4
Success
DES-3026:4#
show cos port_mapping
Purpose
Used to display the current Switch port CoS mapping configuration.
Syntax
show cos port_mapping {port <portlist>}
Description
Use this command to view the current configuration for port-to-class CoS
settings for any or all ports.
Parameters
96
port <portlist>
−
Specifies a port or range of ports to view settings. If no ports
ifi d ll
li
d
