DES-3000 Series Layer 2 Switch CLI Reference Manual
config serial_port
Purpose
Used to configure the serial port.
Syntax
config serial_port {baud_rate [9600 | 19200 | 38400 | 115200] |
auto_logout [never | 2_minutes | 5_minutes | 10_minutes |
15_minutes]}
Description
This command is used to configure the serial port’s baud rate and auto
logout settings.
Parameters
baud rate [9600 | 19200 | 38400 | 115200]
−
The serial bit rate that will be
used to communicate with the management host.
auto_logout
- This parameter will allow the user to choose the time the
Switch’s serial port will be idle before automatically logging out. The user
may choose one of the following.
never
−
No time limit on the length of time the console can be open
with no user input.
2_minutes
−
The console will log out the current user if there is no
user input for 2 minutes.
5_minutes
−
The console will log out the current user if there is no
user input for 5 minutes.
10_minutes
−
The console will log out the current user if there is
no user input for 10 minutes.
15_minutes
−
The console will log out the current user if there is
no user input for 15 minutes.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To configure the baud rate:
DES-3026:4#config serial_port baud_rate 9600
Command: config serial_port baud_rate 9600
Success.
DES-3026:4#
enable clipaging
Purpose
Used to pause the scrolling of the console screen when the show
command displays more than one page.
Syntax
enable clipaging
Description
This command is used when issuing a command which causes the
console screen to rapidly scroll through several pages. This
command will cause the console to pause at the end of each page.
The default setting is enabled.
Parameters None.
Restrictions Only
administrator-level users can issue this command.
Example usage:
15
