DES-3000 Series Layer 2 Switch CLI Reference Manual
show link_aggregation
ports on the Switch (9-10, 17-18, 25-26) and cannot be viewed here.
algorithm
−
Displays the link aggregation algorithm in use on the Switch.
Restrictions None.
Example usage:
To display Link Aggregation configuration:
DES-3026:4#show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = mac_source
Group ID : 1
Type : TRUNK
Master Port : 5
Member Port : 5-7
Active Port :
Status : Disabled
Flooding Port : 0
DES-3026:4#
Example Usage:
To display the link aggregation algorithm set on the switch.
DES-3026:4#show link_aggregation algorithm
Command: show link_aggregation algorithm
Link Aggregation Algorithm = mac_source
DES-3026:4#
config lacp_ports
Purpose
Used to configure settings for LACP compliant ports.
Syntax
config lacp_ports <portlist> mode [active | passive]
Description
This command is used to configure ports that have been previously
designated as LACP ports (see
create link_aggregation
).
Parameters
<portlist>
−
Specifies a range of ports to be configured for LACP.
mode
– Select the mode to determine if LACP ports will process LACP
control frames.
active
– Active LACP ports are capable of processing and
sending LACP control frames. This allows LACP compliant
devices to negotiate the aggregated link so the group may be
changed dynamically as needs require. In order to utilize the
ability to change an aggregated port group, that is, to add or
subtract ports from the group, at least one of the participating
devices must designate LACP ports as active. Both devices must
support LACP.
passive
– LACP ports that are designated as passive cannot
process LACP control frames. In order to allow the linked port
group to negotiate adjustments and make changes dynamically,
at one end of the connection must have “active” LACP ports (see
above).
111
