DES-3000 Series Layer 2 Switch CLI Reference Manual
config bandwidth_control
Purpose
Used to configure bandwidth control on a by-port basis.
Syntax
config bandwidth_control [<portlist>] {rx_rate [no_limit | <value
64-1024000>] | tx_rate [no_limit | <value 64-1024000>]}
Description
The
config bandwidth_control
command is used to configure
bandwidth on a by-port basis.
Parameters
<portlist>
−
Specifies a port or range of ports to be configured for
bandwidth control.
rx_rate
−
Specifies that one of the parameters below (
no_limit
or
<value 64-1024000>
) will be applied to the rate at which the above
specified ports will be allowed to receive packets
no_limit
−
Specifies that there will be no limit on the rate of
packets received by the above specified ports.
<value 64-1024000>
−
Specifies the packet limit, in kbps, that
the above ports will be allowed to receive.
tx_rate
−
Specifies that one of the parameters below (
no_limit
or
<value 64-1024000>
) will be applied to the rate at which the above
specified ports will be allowed to transmit packets.
no_limit
−
Specifies that there will be no limit on the rate of
packets transmitted by the above specified ports.
<value 64-1024000>
−
Specifies the packet limit, in kbps, that
the above ports will be allowed to transmit.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To configure bandwidth control:
DES-3026:4#config bandwidth_control 1-10 rx_rate 100000 tx_rate 100000
Command: config bandwidth_control 1-10 rx_rate 100000 tx_rate 100000
Success.
DES-3026:4#
show bandwidth_control
Purpose
Used to display the bandwidth control configuration on the Switch.
Syntax
show bandwidth_control {<portlist>}
Description
The
show bandwidth_control
command displays the current
bandwidth control configuration on the Switch, on a port-by-port
basis.
Parameters
<portlist>
−
Specifies a port or range of ports to be viewed.
Using this command without adding a portlist entry will show the
bandwidth control for all ports in the Switch stack.
Restrictions None.
Example usage:
To display bandwidth control settings:
95
