DES-3000 Series Layer 2 Switch CLI Reference Manual
24
P
ORT
S
ECURITY
C
OMMANDS
The port security commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config port_security ports
[<portlist> | all ] {admin_state [enable | disable] |
max_learning_addr <max_lock_no 0-10> | lock_address_mode
[Permanent | DeleteOnTimeout | DeleteOnReset]}
show port_security
{ports <portlist>}
delete port_security_entry vlan_name
<vlan_name 32> mac_address <macaddr> port <port>
clear port_security_entry port
<portlist>
enable port_security trap_log
disable port_security trap_log
Each command is listed, in detail, in the following sections.
NOTE:
The uplink module ports (DES-3010F/FL/G ports 9-10, DES-3018 ports
17-18, DES-3026 ports 25-26) do not support the port security function.
config port_security ports
Purpose
Used to configure port security settings.
Syntax
config port_security ports [<portlist> | all] {admin_state [enable |
disable] | max_learning_addr <max_lock_no 0-10> | lock_address_mode
[Permanent | DeleteOnTimeout | DeleteOnReset]}
Description
This command allows for the configuration of the port security feature. Only
the ports listed in the
<portlist>
are effected.
Parameters
ports <portlist>
−
Specifies a port or range of ports to be configured for port
security.
all
−
Configure port security for all ports on the Switch.
admin_state [enable | disable]
– Enable or disable port security for the listed
ports.
max_learning_addr <max_lock_no 0-10>
- Use this to limit the number of
MAC addresses dynamically listed in the FDB for the ports.
DeleteOnTimeout
– The locked addresses will age out after the
aging timer expires.
lock_address_mode [Permanent | DeleteOnTimeout | DeleteOnReset]
–
Indicates the method of locking addresses. The user has three choices:
Only
administrator-level users can issue this command.
Permanent
– The locked addresses will not age out after the aging
timer expires.
DeleteOnReset
– The locked addresses will not age out until the
Switch has been reset.
Restrictions
Example usage:
138
