33
sources will be selected from the currently routed video stream’s
encoder.
Analog Mute:
Enable or disable muting the local analog audio output.
Volume:
Use the slider to set the volume level of the local analog
audio output. The available range is from 0 to 100.
Hostname/IP:
Type the hostname or IP address of the Encoder to
stream audio from.
Note: The hostname of an Encoder can be found on the System tab
in the Info section. Generally speaking, when receiving a stream from
outside of your local network, an IP address will be required.
Source:
Select which audio input from the currently selected audio
source to output.
Note: When free routing is disabled, audio will be selected from the
local analog and HDMI inputs.
Port:
Type the streaming port used by the streaming source.
3) Video Wall:
This section allows the user to design, edit and manipulate
the video wall settings of this unit. Video walls should be created using
multiple receiver units connected to identical displays. The bezel size of
the displays being used, as well as the horizontal and vertical monitor
count, is defined here. Pressing the “Save” button will activate the
associated settings.
Note: These settings will only be used when the decoder’s display mode
is set to “Video Wall”.
