11
ETHERNET
2ND LEVEL
3RD LEVEL
4TH LEVEL
IP
[Current IP Address]
MAC
[Unit’s MAC Address]
1) IP Mode:
Set the unit to Static or DHCP mode. When DHCP mode is
selected, all IP address information will be assigned automatically by the
local DHCP server. When Static is selected, the IP address, netmask and
gateway must be set manually using the “Setup Static IP” menu.
Note: The unit is set to DHCP by default.
2) Static IP Setting:
The unit’s static IP address, netmask, and gateway
address can be set here. Press the “Enter” button to begin editing the
address and use the “+” and “-” buttons to adjust each value. Press the
“Enter” button to store the current number segment and move to the next
segment.
Note: These values can be set even when the unit is in DHCP mode, but
they will not be used until the mode is changed to Static IP.
3) IP
: Displays the unit’s current IP address.
4) MAC:
Displays the unit’s MAC address.
FACTORY
2ND LEVEL
3RD LEVEL
Reset
1) Reset:
Pressing the “Enter” button will cause a reset confirmation
window to pop up. Press the “Enter” button again, within 10 seconds, to
reset all of the unit’s settings back to their factory defaults.
INFORMATION
2ND LEVEL
3RD LEVEL
SN
[Unit’s Serial Number]
Version
[Current Firmware Version]
1) Information:
This screen displays information about the unit’s serial
number and the current firmware version.
