CynkoMet N-235 Series, Instructions For Use And Operation

Page: 42 / 124

Cynko Met
N-233
42
When connecting the braking system (two-wire pneumatic), the
correct sequence of connecting hoses is important. Hoses are designated by
color by means of colored protective covers.
The first thing to do is connect the plug marked yellow to the yellow
socket in the tractor, and then the plug marked in red to the red socket in
the tractor.
In order to disconnect the spreader from the tractor, perform the
following steps:
•
switch off the engine and remove the keys from the ignition
•
pull the parking brake in the tractor and spreader
•
if the spreader with the cargo is located on a steep slope, it should be
protected additionally against rolling by planting chocks under the
machine's wheel.
•
disconnect the hydraulic, electrical and brake system cables of the trailer
from the spreader.
•
disconnect the drawbar from the tractor transport hitch and drive the tractor
away.
NOTE!
NOTE!
When disconnecting the spreader from the tractor, keep
particular caution.
Provide yourself a good visibility. Before disconnecting the hoses
and rods, the cabin of the tractor must be closed to prevent it
from unauthorized access. The tractor engine is to be turned off
and remove the key from the ignition.
NOTE!
NOTE!
Pay attention to the compatibility of oils in the tractor hydraulic
system and the hydraulic system of the spreader.
4.3.6 Loading the cargo box.
NOTE!
NOTE!
Loading of the cargo bed can take place only when the spreader is
connected to the tractor, set on level ground, and when the parking
brake is engaged on the tractor and spreader.