CynkoMet N-235 Series, Instructions For Use And Operation

Page: 15 / 124

Cynko Met
N-233
15
3. Safety in use
3.1 General safety and accident prevention regulations
•
Before using the spreader, you should carefully read the contents of the
instruction manual. During operation, adhere to all instructions contained in
the manual.
•
Before every start-up, check the spreader for operational safety
(completeness of all screens, tightness of all the screws, if there are no
cracks on the structure or visible damage, proper tension of the feeder
chain (section 6.8)).
•
Entering the spreader is possible only during absolute motionlessness of the
machine and
disconnection of the Power take-off (PTO) from the
tractor.
•
The spreader should be combined with tractors recommended by the
manufacturer accordingly to table 3 (section 4.1).
•
When using the machine, pay special attention to marked crushing and
cutting points, as well as to all pictograms on the spreader.
•
During transport, check the condition of preheat of the tires, brake drums
and wheel bearings. In the case of detecting an excessively heating element,
stop the machine from operating until the cause is determined, and then
rectify the fault.
NOTE!
NOTE!
Before driving with the spreader in a place where there are
flammable materials you should imperatively check the status of
the heating elements of the spreader, especially the brake
drums and driving wheel bearings, due to the risk of fire.
•
The speed of driving must always be adapted to the environmental
conditions.
•
When coupling and decoupling the machine to/from the tractor, you must
take special caution.
•
Exceeding the permissible load can cause accidents on the road and
damage to the machine.
•
When cornering, you should take into account the inertia of the machine.