CynkoMet N-235 Series, Instructions For Use And Operation

Page: 53 / 124

Cynko Met
N-233
53
NOTE!
NOTE!
If you need to lift the wheels of the spreader, observe the
following rules:
- the spreader attached to the tractor is to be set in the direction for
driving straight ahead on a flat, stable base, and then tractor’s parking
brake is to be engaged,
- plant securing chocks under the wheel of the spreader that will not
be raised,
- place the jack under the load-bearing beam in a stable place and
lift it up,
- secure the spreader against falling down in the event of a jack
failure by placing a stable support under the machine.
NOTE!
NOTE!
In the case of noting any irregularities in the operation or
damage to systems or assemblies of the spreader, the
machine must be taken out of use until repair and removal of
defects.
It is forbidden to carry out service and repair work under
a burdened cargo bed and with the tractor engine running. All
maintenance work performed after disconnecting the PTO.
All maintenance and repair tasks are to be performed in
compliance with general occupational health and safety rules.
In the case of injury, the wound should immediately be
washed and disinfected. In the case of serious injuries, consult
a physician.
Table 8: Orientational tightening torques for screws
Metric thread
Screw class
5.8 8.8 10.9
Nm
M6 5 7 11
M8 12 18 26
M10 23 35 52
M12 40 60 89