CynkoMet N-235 Series, Instructions For Use And Operation

Page: 58 / 124

Cynko Met
N-233
58
their date of manufacture, unless previously found to be damaged and
replaced.
In the case of noting oiling on the body of the hydraulic cylinder,
check the nature of the leak. When fully taking out the cylinder actuator,
check all sealing places. Minor leaks with symptoms of "sweating" are
acceptable, but if you see a leak of a "drip" type, you must stop the
spreader’s operation and repair the failure.
NOTE!
NOTE!
The state of the hydraulic system should be controlled up to
date during its use. It is prohibited to use a machine with a
damage hydraulic system of the rear wall or brakes.
6.5 Maintenance of the drive axle.
Maintenance of the drive axle is based on continuous inspection of the
condition of brakes and leaf springs and checking for cracks. It should not
be permitted for a thick layer of dried mud to accumulate on the system.
NOTE!
NOTE!
In the case of noticing a cracked part, e.g. a bow screw or
leaf spring, the machine should be out of operation until the
fault has been rectified.
6.6 Mounting the adapter's drum guard
The guard of the adapter's drums is required for driving with the
spreader on public roads. The spreader is delivered with the lever serving to
open the guard dismounted. Figure 13 presents the mounting procedure.