Cushman Hauler 4x4 Crew Diesel 2019, Operator'S Manual

Page: 56 / 72

54
MOD097A
3. Install the rubber boot making sure it
is sealed around the bulb and connect
the wire harness.
MOD098A
4. Adjust the headlight (see Checking/
Adjusting Headlight Aim in this sub-
section).
Taillight/Brake Light
Assembly
If one or more individual LED bulbs are
not working, the taillight/brake light
assembly must be replaced.
MOD096
To replace the taillight/brake light assem-
bly, use the following procedure:
1. Remove the four screws from the
inner cargo box side panel, two rear
tie-down screws and one tailgate
latch bail screw; then remove the six
screws from the underside of the
cargo box and remove the outer cargo
box side panel.
MOD114A
MOD115A
2. Remove screw (A); then flex the
cargo box fender away from the cargo
box to access and remove screw (B).

NOTE: A long extension with a
socket or long screwdriver will be
needed to access screw (B).
MOD117A
CAUTION
When replacing the headlight bulb,
be careful not to touch the glass por-
tion of the bulb. Grasp the new bulb
with a clean rubber gloves.