Cushman Hauler 4x4 Crew Diesel 2019, Operator'S Manual

Page: 55 / 72

53
3. Elevate the vehicle.
4. Remove the lug nuts.
5. Remove the wheel.
6. Install the wheel and install the lug
nuts.
7. Install the wheel and tighten the
wheel nuts in 25 ft-lb increments to a
final torque of 100 ft-lb.
8. Remove the jack.

NOTE: Whenever the wheels are
removed and installed onto the hub
and the lug nuts are tightened, refer
to the Maintenance Schedule found
on page 39 to identify the appropri-
ate service interval requiring the
tightening of the lug nuts.
Muffler/Spark Arrester
The muffler has a spark arrester which must
be periodically cleaned. At the intervals
shown in the Maintenance Schedule, clean the
spark arrester using the following procedure.
1. Remove the cap screw securing the
spark arrester assembly to the muf-
fler.
MOD095A
2. Using a suitable brush, clean the car-
bon deposits from the screen taking
care not to damage the screen.

NOTE: If the screen or gasket is
damaged in any way, it must be
replaced.
3. Install the spark arrester assembly
and secure with the cap screw.
Tighten to 60 in.-lb.
Light Bulb Replacement

NOTE: The bulb portion of the
headlight is fragile. HANDLE WITH
CARE. When replacing the head-
light bulb, do not touch the glass
portion of the bulb. If the glass is
touched, it must be cleaned with a
dry cloth before installing. Skin oil
residue on the bulb will shorten the
life of the bulb.
To replace the headlight bulb, use the fol-
lowing procedure.
1. Disconnect the wiring harness; then
remove the rubber boot from the light
assembly.
MOD046
MOD096
2. Remove the old H4 bulb by unlock-
ing the spring; then insert the new
bulb into headlight assembly and lock
the spring to secure the bulb.
! WARNING
Wait until the muffler cools to avoid
burns.
CAUTION
Use only specified bulbs indicated in
the Specifications chart as replace-
ment bulbs.