Cushman Hauler 4x4 Crew Diesel 2019, Operator'S Manual

Page: 35 / 72

33
Diagnostic Trouble Codes
Oil Level Stick
There is an oil level stick for checking
the engine oil level. To check the oil
level, use the following procedure:

NOTE: The vehicle should be on
level ground when checking the
engine oil level.
Preference is to
check before operating or at
least one hour after use.
1. Lift the cargo box.
2. Remove the oil level stick and wipe it
with a clean cloth.
MOD063
3. Install the oil level stick.

NOTE: The oil level stick should be
fully seated for checking purposes.
4. Remove the oil level stick; the engine
oil level should be within the operat-
ing range.
MOD-OIL-DA
5. To add oil, the cargo box must be
tilted up. Remove the oil fill cap.
After adding oil, install the oil fill cap
and tighten securely.
Display Fault Description
C0063 Tilt Sensor Circuit High
C0064 Tilt Sensor Circuit Low/SG/Open
P0119 Engine Coolant Temp Sensor Circuit
Intermittent
P0217 Engine Coolant Over Temperature
Detected
P0370 Loss of Crankshaft Position Sensor
Synchronization/Gap Position
P0372 Crankshaft Position Sensor Missing
Tooth
P0373 Crankshaft Position Sensor Spike
Detected
P0480 Fan-Primary Relay Control Circuit
P0500 Vehicle Speed-Sensor
P0562 System Voltage Low
P0563 System Voltage High
P0615 Starter Relay Circuit
P0616 Starter Relay Circuit Low
P0617 Starter Relay Circuit High
P0627 Fuel Pump Control Circuit Open
P0628 Fuel Pump Control Circuit Low/SG
P0629 Fuel Pump Control Circuit High/SP
P0630 VIN Not Programmed or Incompatible
P0641 Sensor Reference Voltage #1 Circuit
Low/Open
P0643 Sensor Reference Voltage #1 Circuit
High
P0691 Cooling Fan #1 Circuit Low/SG
P0692 Cooling Fan #1 Circuit High/SP
U0100 Lost Communication with ECM
U0155 LCD Gauge to EFI ECM CAN Com-
munication Lost
FUEL
OFF Tilt Sensor Activation Code
CAUTION
The vehicle should be on level
ground when checking the engine oil
level. If the oil level is lower than the
“ADD” line, only add oil if the engine
oil has had sufficient time to drain
back to the oil pan after operation.
Preference is to check before operat-
ing or at least one hour after use.
! WARNING
Do not overfill the engine oil. Always
make sure the oil level is within the
operating range but not above the
FULL mark.