![background image](http://html1.mh-extra.com/html/curtis/kubota-m62-tlb/kubota-m62-tlb_installation-and-owners-manual_2699754031.webp)
31 of 37
9. Move the boom to fully raising position and raise the
backhoe by operating the stabilizers until the mount
bar on the backhoe main frame are slightly higher than
the tractor main frame support hooks.
NOTE:
If the support hooks are not parallel to the mount
bars, adjust the stabilizers.
(1)
Mount
bar
(2)
Support
hook
10. Move the tractor backward until the support hooks on
the tractor main frame are just beneath the mount bar
on the backhoe main frame.
(1)
Guide
stop
(2)
Mount
bar
(3)
Support
hook
11. Lower the mount bar onto the support hooks by
operating the stabilizer and boom control levers.
12. Move the boom slowly to the lowering position, and
engage the guide plates of the main frame to the
bosses of the tractor main frame. Then raise the rear
wheels slightly by operating the boom to the lowering
direction.
13. Shut off the engine. Reinstall the mounting pins, and
insert the slide bar of the mounting pins to the hole of
the main frame.
(1)
Moun ng
pin
(2)
Slide
bar
NOTE:
Move the tractor / loader / backhoe to an open area and
cycle all backhoe functions. This will check their
operation and flow oil back through the system, filtering
it and refilling each circuit. Check the hydraulic oil level
before putting the backhoe into full operation. See
"MAINTENANCE" section of the tractor operator's
manual for oil type and correct level.
14. Thread both hand screws through backhoe mounting
plates into the rear panel tube to secure it.
(A) Hand screw
OPERATION