![background image](http://html1.mh-extra.com/html/curtis/kubota-m62-tlb/kubota-m62-tlb_installation-and-owners-manual_2699754021.webp)
21 of 37
Figure 18.5: Fasten Backhoe Cab
STEP 18: Backhoe Cab Cont.
18.5 Fasten the backhoe cab to the backhoe cab footers, but
be sure to leave the bolts loose (see Figure 18.5,
outriggers hidden for clarity).
Hardware Used
QTY
5/16-18 x 1 Hex Head Flanged Cap Screw 6
5/16
Flat
Washer
6
5/16-18 Flanged Nylon Lock Nut
6
18.6
Fasten the backhoe cab hand screw assembly cables to
the backhoe cab (see Figure 18.6)
Hardware Used
QTY
#10-32 x 1/2 Phillips Head Machine Screw 2
#10-32 Flanged Nylon Lock Nut
2
18.7 Rotate the backhoe cab forward and secure backhoe
cab to the rear panel with the adjustable handles (see
Figure 18.7). Note: An additional clamp can be used in
order to compress the foam seal and allow the slot and
threaded insert to align for easier hand screw
installation.
18.8
Adjust the lower portion of the backhoe cab so that
there is an even crush on the foam seal against the rear
panel and then tighten the bolts securing the cab to the
footer plates.
18.9 Install backhoe cab side windows (see Figure 18.9).
18.10 Connect the wiring for the wiper harness and check to
make sure wiper functions properly.
18.11 Install the supplied rubber floor mat onto the backhoe
floorboards. Be sure to push the mat under the side
fillers for best seal.
Fig. 18.7: Secure Backhoe Cab Hand Screws
Figure 18.9: Backhoe Cab Side Windows
INSTALLATION
Fig. 18.6: Hand Screw Assembly
#10 nut
#10 screw
Hand Screw
cable