![background image](http://html1.mh-extra.com/html/curtis/kubota-m62-tlb/kubota-m62-tlb_installation-and-owners-manual_2699754015.webp)
15 of 37
STEP 8: Lower Rear Panel Brackets
8.1 Remove the bottom M14 bolt from the side of the ROPS
tube and save for re-use.
Note: Do not remove both bolts at the same time as the
ROPS may settle and is difficult to reposition.
8.2 Fasten the left lower rear panel bracket to the vehicle using
the OEM bolt (see Figure 8.1, wheel and backhoe hidden
for clarity). Leave hardware loose.
8.3 Remove the upper M14 bolt from the side of the ROPS
tube and re-fasten through the remaining hole in the
bracket. Attach lower rear panel bracket to the rear panel
tube.
Hardware Used
QTY
5/16-18 x 3/4 Hex Head Flanged Cap Screw
2
8.4 Repeat steps 8.1 through 8.3 on right hand side.
STEP 9: Heater Duct
9.1 Fasten the rear of the heater duct to the rear panel (see
Figure 9.1). Leave hardware loose.
Hardware Used
QTY
5/16-18 x 3/4 Hex Head Cap Screw
2
9.2 Fasten the front of the heater duct to the cowl (see Figure
9.2). Leave hardware loose.
Hardware Used
QTY
5/16-18 x 3/4 Hex Head Cap Screw
2
9.3 Fasten the corner of the heater duct to sideframe (see
Figure 9.3). Leave hardware loose.
Hardware Used
QTY
5/16-18 x 3/4 Hex Head Cap Screw
1
5/16-18 Flanged Nylon Lock Nut
1
Figure 8.1: Left Lower Rear Panel Bracket
Figure 9.1: Heater Duct Rear Bolts
Figure 9.2: Heater Duct
Figure 9.3: Side Frame Bolt
3/4” Long Screw
Flanged Nut
3/4” Long Screws
INSTALLATION
5/16-18 Screws
OEM M14 Screws