5 of 37
Check and tighten all hardware after 20 hours of operation. Periodically inspect and tighten hardware for
the remainder of the unit’s service life. Keep the enclosure components clean in order to prevent dust
and dirt from forming an unattractive film. The life of your cab components depend upon following these
care procedures:
1.
NEVER USE
AN ABRASIVE DETERGENT / VEHICLE CLEANER OR A WIRE BRISTLED BRUSH.
Do not use any
CITRUS BASED CLEANERS
such as orange or lemon.
2. Clean the enclosure surfaces thoroughly with warm soapy water and a COTTON cloth or chamois.
Be sure to use mild soap, specifically a dish liquid or equivalent. Clean in a light circular motion for
best results.
3. Remove grease and oil with mineral spirits and a COTTON cloth or chamois.
CARE & MAINTENANCE
All installation procedures listed within this manual are generally representative of the machine
model for which the manual is written.
Your machine may be configured differently (e.g. SP1 vs. SP2,
etc.), but the outline for the procedure should still be followed. For further support for any issues not
covered within the pages of this manual, please contact Curtis Industries.
TOOLS REQUIRED:
Standard and Metric Wrenches
Standard and Metric Sockets
Torque Wrench
Allen Wrenches (T-Handle Recommended)
Razor Knife
Needle Nose Pliers
Grease
Measuring Tape
Silicone (black or clear)
Scissors
Snips
Electrical Tape
Drill
11/32” Drill Bit
Metal Cutting Saw (sawsall or cutoff wheel)
Teflon Tape
GENERAL INFORMATION
