Cumberland 064-11343, Installation Manual

Page: 36 / 138

Chapter 2: Pre-Installation Planning
WARNING
Warranty is void if product is used in a manner not specified by the manufacturer.
EDGE 4IN-6R-2LD Modules Operating System
The EDGE 4IN-6R-2LD modules are only compatible with EDGE 2 Controllers.
IMPORTANT: Make sure to order the correct EDGE Main Controller, once it is mounted to the wall, the
product may not be returned.
High Voltage Area Identification
The high voltage area is outlined on the PCB board by a white line that defines the high voltage area from
the low voltage area.
Figure 2-5 PCB High Voltage Area
DANGER
High Voltage! Turn off the main electrical disconnect switch prior to servicing any
electrical equipment. Failure to do so can cause serious injury or death.
GND1, GND2, GND3, and GND4 test points are high voltage.
WARNING
Installation must only be performed by qualified service personnel.
Usable Light Bulb Types
The EDGE 4IN-6R-2LD modules can only control one type of dimmable CFL/CCF/LED per zone. Using
multiple types, wattages or brands of CFL/ CCFL/LED can create interferences that can cause the
module to work improperly.
NOTE: CFL and CCFL lamps must be ELV ballast type (electronic only)
Warm up lights before dimming
The dimmable CFL/CCFL/LED bulbs may be exposed to various temperature conditions during storage
and transportation. Turn the lamps ON at 100% for 24 hours after the first installation before dimming.
36 890–00687 EDGE 2