6
56
CUES Inc.
,
LAMPII User Manual | LM903
www.cuesinc.com
,
OPERATING THE LAMPII
OPERATING THE PICTURE IN PICTURE (PIP)
The LAMPII is equipped with picture in picture (PIP) capabilities. This allows the video from the
two cameras to be viewed simultaneously on the monitor in various ways. The PIP is equipped
with the following functions and controls
(see the figures below and additional instructions in
LT600-INST):
PIP INSTALLATION
NOTE: All BNC video connections at the rear of the Telpix PiP unit have been completed during
assembly at CUES. Do not disconnect or move any of the BNC connectors as the unit will not
perform correctly. Make all connections to the RCA connectors located at the rear of the right
side mounting bracket (located at the left side in the rear view below).
For the following steps, refer to view below:
1. Connect the RCA cable from the mainline camera to the RCA connector labeled “main”
on the rear of the pip mounting bracket.
2. Connect the RCA cable from the lateral camera to the RCA connector labeled “lat” on the
rear of the pip mounting bracket.
3. Connect the RCA cable from the monitor/VCR to the RCA connector labeled “MON” on
the rear of the pip mounting bracket.
4. NOTE: Use only the supplied Telpix power adapter to connect to AC power. Use of any
other adapter may result in damage to the unit. Connect the supplied power cable to the
“DC IN” connector located at the lower right side of the Telpix unit.
THE PIP SECTION BELOW IS
FOR 1208 PCU SYSTEMS ONLY!