6
CUES Inc.
,
LAMPII User Manual | LM903
59
www.cuesinc.com
,
EQUIPMENT MAINTENANCE
1. Clean the LAMPII equipment with detergent and water after each day of use.
2. Prior to use, check all cables coming from the transporter and launcher for cuts or
worn areas. If wear on the cables is discovered, the cables should be repaired or replaced
immediately. Do not operate the LAMPII with worn or cut cables.
3. Never remove the cover from the motor or controllers. These areas contains delicate
electronic components. Opening any of these areas will result in the warranty being voided.
4. Carry the LAMPII by it’s frame rather than the TV cable.
UNDERBODY WEAR PLATE INSPECTION / MAINTENANCE
For alternate push configurations, periodically inspect the leading edge of the wear plate (P/N
LM740) shown in GREEN in the picture below. This wear plate protects the LAMPII body from
push cable wear and should be replaced if the leading edge is broken, or severely grooved to avoid
costly repairs to the transporter itself.
The plate is attached with four screws: P/N 103045 in LM350-2, -4, & -9 configurations, and P/N
HW2818 in LM350-6,-7,-8, & -10 configurations(a cover is also present in these configurations).
