QuickMedia™ Receiver/Processor Crestron
QM-RMCRX-BA
Slot 6: C2I-RXBA-VIDEO
The C2I-RXBA-VIDEO module is built into slot 06 of the QM-RMCRX-BA.
The QM-RMCRX-BA provides one QM input, labeled QM, which receives
composite video, S-video and RGB video as well as digital audio from a
QuickMedia transmitter such as the QM-WMC or QM FlipTop box.
The QM-RMCRX-BA provides the following video outputs:
•
One BNC output labeled VIDEO for composite video.
•
One mini-DIN output labeled S-VIDEO for S-video.
•
One RGB output labeled RGBHV for computer video.
The C2I-RXBA-VIDEO module can route any video source to the
corresponding output for transmission to the display device.
The QM-RMCRX-BA supports up to 254 skew presets, where a skew preset
consists of three RGB skew values together with peaking and boost. Each skew
preset applies to the cable connection between the QM-RMCRX-BA and a
specific QM transmitter.
During normal program operation the system will recall a pre-configured preset
corresponding to the transmitter currently connected to the QM-RMCRX-BA. If
automatic video compensation is NOT enabled, the program must supply the
correct preset number using the
<SkewPreset#>
analog and recall the preset
manually.
If auto-compensation is enabled (via the
<EnableVideoAutoComp>
input),
then
<SkewPreset#>
is ignored and the QM-RMCRX-BA will automatically
extract the correct preset number directly from the transmitter's QM signal.
Depending on how the transmitter is configured, the QM signal will be
identified by a Transmitter ID (XMIT ID) or Cresnet ID. Auto-compensation
mode thus allows for an easier way to recall presets during runtime.
46
•
QuickMedia™ Receiver/Processor: QM-RMCRX-BA
Operations Guide - DOC. 6332
