Product Manual – DOC. 7839M
DM-NVX-35x(C) Encoders/Decoders
•
3
LAN 1: 8-pin RJ-45 connector, female;
100BASE-TX/1000BASE-T Ethernet port;
PD (powered device) port compatible with UPOE compliant Ethernet switch,
Crestron DM-PSU-ULTRA-MIDSPAN, or approved third-party PSE;
Green LED indicates Ethernet link status;
Amber LED indicates Ethernet activity
LAN 2: 8-pin RJ-45 connector, female;
100BASE-TX/1000BASE-T Ethernet port;
1
Green LED indicates Ethernet link status;
Amber LED indicates Ethernet activity
LAN 3: SFP port;
Accepts one Crestron SFP-1G Series SFP transceiver module;
Green LINK LED indicates Ethernet link status;
Green ACT LED indicates Ethernet activity
HDMI OUTPUT: 19-pin HDMI® Type A connector, female;
HDMI digital video/audio output (DVI compatible);
Green LED indicates video signal transmission at the HDMI output
HDMI INPUTS 1
–
2: 19-pin HDMI Type A connectors, female;
HDMI digital video/audio inputs (DVI and Dual-Mode DisplayPort™ compatible);
4, 5
Two green LEDs, each indicates sync detection at the corresponding HDMI input
AUDIO I/O: 5-pin 3.5 mm detachable terminal block;
Balanced/unbalanced stereo line-level audio input or output;
Input Impedance: 24k Ohms balanced/unbalanced;
Maximum Input Level: 4 Vrms balanced, 2 Vrms unbalanced;
Output Impedance: 200 Ohms balanced, 100 Ohms unbalanced;
Maximum Output Level: 4 Vrms balanced, 2 Vrms unbalanced
1
Either LAN 1 or LAN 2 can be used as the primary LAN connection, allowing the other port to be used for
connection to a local network device or to another DM NVX device. If one of the ports is used as the primary
LAN connection, the port requires connection to a 1000BASE-T switch in order to stream network video.
2
The DM-NVX-350 and DM-NVX-351 can be powered by the connection of LAN 1 to a UPOE compliant
Ethernet switch, a Crestron DM-PSU-ULTRA-MIDSPAN, or other Crestron approved power injector (sold
separately). For additional information, refer to Answer ID 5791 in the Online Help section of the Crestron
website (
). The DM-NVX-350 and DM-NVX-351 can also be powered using the
included power pack.
3
LAN 3 can be used as the primary LAN connection or can be connected to another DM NVX device. LAN 3 can
connect to a fiber-optic network using the appropriate Crestron SFP-1G transceiver module (sold separately).
Refer to the SFP-1G Series Installation Guide (Doc. 7979) for information about installing Crestron SFP-1G
Series transceiver modules.
4
HDMI connections require an appropriate adapter or interface cable to accommodate a DVI or Dual-Mode
DisplayPort signal. CBL-HD-DVI interface cables are sold separately.
5
Device control via CEC requires the use of a Crestron 3-Series® or later control system.
Summary of Contents for DigitalMedia DM-NVX-350
Page 6: ......
