![background image](http://html1.mh-extra.com/html/crary/cws-1010/cws-1010_owners-manual_2679352022.webp)
PN 26037-00 R072208
18
ASSEMBLY
4.8 geaRbox/fan mounT - ‘95 and laTeR SeRieS (15-22.5 fT. headeRS)
Position the mount plate support on the back of the header
1.
as shown in Figure 15 and clamp in place.
Mark and drill the four 27/64” (.4218”) holes and tap to 1/2-13
2.
NC for the mount plate support.
Attach the mount support plate to the header with four
3.
1/2” x 1-1/4” serrated flange bolts and washers. Torque to
75 ft-lbs.
Attach gearbox mounting plates to the mount plate support
4.
with 1/2” x 1-1/4” serrated flange bolts (Figure 16). Do not
tighten at this time.
Lift the gearbox/fan into position using a floor jack or over-
5.
head hoist and attach to the mounting plates with four 1/2”
bolts and washers. Do not tighten at this time.
Check the gearbox and, if necessary, fill the gearbox with
6.
lube before use.
Use Mobilube SHC 75W-90 synthetic gear lube or
equivalent with the following specifications:
API Service GL-5/MT.1
MIL-L-2105D
MACK GO-j PLUS
SAE j2360
Capacity: 40 oz. (1.2 L)
Keep gearbox/fan suspended with hoist or jack to install the
7.
right hand drive kit.
Figure 15, Gearbox/fan mount dimensions (1995 and later headers 15’-22.5’)
Place all controls in neutral or off, stop combine engine, set
parking brake, remove ignition key, wait for all moving parts to
stop, then properly block machine before servicing, adjusting,
repairing, or unplugging.
WaRning
Summary of Contents for CWS 1010
Page 35: ...PN 26037 00 R072208 31 ASSEMBLY Figure 27 Air hose installation 4 15 FAN HOSE ASSEMBLY...
Page 54: ......
Page 55: ......