Crary CWS 1010, Owner'S Manual, Page: 17 / 56

PN 26037-00 R072208 13
ASSEMBLY
4.4 elecTRic acTuaToR
Adjust reel arm mounts to desired position and torque all 1.
1/2” hardware to 75 ft-lbs.
Slide the pivot clamp onto the RH side of the manifold (Figure 2.
9). Loosely tighten the 3/8” x 1-1/2” bolts and nylock nuts.
Attach the base end of the electric actuator to the reel mount 3.
assembly with a 1/2” x 2-1/2” bolt and locknut.
Adjust the manifold so the air tubes point directly behind the 4.
cutterbar. The reel tines should extend past the air tubes.
Manually turn the reel to ensure that the tines follow the curve
of the air tubes as they rotate downward (Figure 10).
Extend the actuator rod 2 inches. 5.
Bolt the actuator rod to the clevis on the pivot clamp with a 6.
1/2” x 2-1/2” bolt and locknut.
Tighten the pivot clamp hardware once the manifold and air 7.
tubes are properly positioned.
Figure 9, Electric actuator
Figure 10, Air tube adjustment
4.5 headeR pRepaRaTion
Clearance of 42” is required between the outside edge of the RH
tire and the RH inside edge of the header in order to mount the
standard fan/gearbox.
A gearbox/fan extension kit can be purchased for headers smaller
than 20’ on combines with dual tires (See Section 4.15 for instal-
lation instructions).
pRe ‘93 headeRS
No disassembly required.
‘93 and afTeR headeRS (15 fT - 22.5 fT)
On RH side of header, remove the driveline clutch assembly and
shielding and set aside. These components will not be used in
reassembly.
‘93 and afTeR headeRS (25 fT - 30 fT)
Remove the OEM PTO driveline from the auger drive 1.
shaft.
Remove the OEM drive shaft shield and door assembly. 2.
Remove the OEM clamp from the auger drive shaft. Then, 3.
remove the OEM sprocket and hub from the RH end of the
drive shaft.
Remove all OEM drive shaft bearings except the far RH 4.
bearing. Also, remove the OEM auger drive shaft.
Set parts aside. All removed parts will be reused except the 5.
OEM bearings and auger drive shaft.
Place all controls in neutral or off, stop combine engine, set
parking brake, remove ignition key, wait for all moving parts to
stop, then properly block machine before servicing, adjusting,
repairing, or unplugging.
WaRning