Crary CWS 1010, Owner'S Manual, Page: 18 / 56

PN 26037-00 R072208
14
ASSEMBLY
4.6 geaRbox/fan mounT - pRe 1993 SeRieS
Position the mount plate support on the back of the header 1.
as shown in Figure 11 and clamp in place. Refer to the fol-
lowing table for Dimension “A.”
Mark and drill the four 27/64” (.4218”) holes and tap to 1/2-13 2.
NC for the mount plate support.
headeR WidTh dim. “a”
15’ 9”
17.5’ 24”
20’ 39”
22.5’ 39”
25’ 54”
30’ 84”
Figure 11, Gearbox/fan mount dimensions (Pre 1993 series)
Attach the mount plate support to the header with four 3.
1/2” x 1-1/4” serrated flange bolts and washers. Torque to
75 ft-lbs.
Attach gearbox mounting plates to the mount plate support 4.
(Figure 12) with 1/2” x 1-1/4” serrated flange bolts, washers
and nuts. Do not tighten at this time.
Lift the gearbox/fan into position using a floor jack or over- 5.
head hoist and attach to the mounting plates with four 1/2”
bolts and washers. Do not tighten at this time.
Check the gearbox and, if necessary, fill the gearbox with 6.
lube before use.
Use Mobilube SHC 75W-90 synthetic gear lube or
equivalent with the following specifications:
API Service GL-5/MT.1
MIL-L-2105D
MACK GO-j PLUS
SAE j2360
Capacity: 40 oz. (1.2 L)
Keep gearbox/fan suspended with hoist or jack to install the 7.
right hand drive kit.
Place all controls in neutral or off, stop combine engine, set
parking brake, remove ignition key, wait for all moving parts to
stop, then properly block machine before servicing, adjusting,
repairing, or unplugging.
WaRning