Crary CWS 1010, Owner'S Manual, Page: 15 / 56

PN 26037-00 R072208 11
ASSEMBLY
4.2 manifold
Figure 6, Mounting the manifold (left hand)
Figure 7, Mounting the manifold (right hand)
If your CWS was shipped with one manifold, skip to step 2. 1.
Otherwise, follow either step A or B, depending on the width
of your header.
18’-22.5’ headers: a. Bolt the right and left manifold sec-
tions together with eight 3/8” x 1-1/2” bolts and nylock
nuts. (Figure 5) The baffle plate should be installed
between the two sections. The hole of the baffle plate
should be on the bottom. Make sure all air holes are
pointing the same direction and torque hardware to
30 ft-lbs.
25’-35’ headers: b. Bolt the RH and LH manifold ends to
the center manifold using eight 3/8” x 1-1/2” bolts and
nylock nuts for each end (Figure 5). Install the baffle
plate between the right and center sections. The hole of
the baffle plate should be on the bottom. Make sure the
air holes of all sections are pointing the same direction
and torque hardware to 30 ft-lbs.
Slide a brace clamp over each end of the manifold. 2.
Set the manifold in the reel mount assemblies. The brace 3.
clamps should be positioned inside the reel mount assem-
blies (Figures 6 & 7). Center the manifold.
Secure the manifold in the reel mount assemblies by bolting 4.
a half clamp to each reel mount assembly. Use four 3/8” x
1” carriage bolts and nylock nuts per half clamp. Insert the
bolts from the bottom.
Slide the brace clamps against the inside of the reel mount 5.
assemblies and tighten the clamps on the manifold.
Slide a tube cap onto the LH end of the manifold and secure 6.
it with an 8-3/8” t-bolt clamp.
Figure 5, Sectional manifold assembly