Crary CWS 1010, Owner'S Manual, Page: 13 / 56

PN 26037-00 R072208 9
Section
aSSemblY
4
4.1 Reel aRm mounT
4.1.1 lefT hand
Bolt reel arm mount plates onto the OEM reel support bracket 1.
with two 1/2” x 1” bolts and nuts per plate. Mount as shown
in Figures 1 & 2.
Measure 7-1/4” forward from the center of the mount plate 2.
bolt shown in Figure 2. Mark and drill a 17/32” hole through
the OEM reel support bracket in this location.
Place an arm mount tube between the reel arm mount plates 3.
and install it in the top hole with a 1/2” x 3” bolt, washers
and nut.
Insert the LH reel mount assembly into the arm mount 4.
tube.
Attach the notched end of the adjustment strap to the arm 5.
mount tube and the LH reel mount with a 1/2” x 3” bolt,
washers and nut. Install the strap with its notches pointing
down.
Remove the OEM spacer at the front of the OEM reel sup- 6.
port bracket. Use the existing 1/2” hardware to install the
bottom end of the adjustment strap and the OEM spacer in
the previously drilled hole.
Figure 1, Reel arm mount (left hand)
Figure 2, Reel arm mount plates