CABRIOLE’
CRAMARO TS S.r.l. – 37044 COLOGNA V.TA (VR) - VIA QUARI DESTRA, 71/G TEL. +39 0442/411688 / FAX + 39 0442/411690
E-MAIL [email protected] WEBSITE: http://www.cramaro.com -
Manual n° MCA016-EN-ED00 – date 15/01/15
page
44
FIG 69
2
3
FIG 70
1
1
(the front of the sheet is smooth, while the back has
metal eyelets to anchor the "
TAIL
"
to the rear door of the container), position it on the edges
of the container almost in proximity to the front cab-shield of the container,
at this point of the assembly, you must install the
pulling ropes, an essential operation requiring
the utmost attention.
- ASSEMBLING THE SIDE PULLING ROPES -
1. Thread the loose ends of the side ropes coming out of the bow package under the front inclined brackets, then on
the front pulleys (
the large Ø 180 mm ones
), then on the tensioning pulleys (
the small Ø 60 mm ones
) that are
secured to the external front supports of the pulling unit (in the event of a kit with rear tensioning system, go
directly to the next point).
2. Thread the side ropes on the rear pulleys (
the medium Ø 100 mm ones
) and then through the
rear safety
rings.
Once this step has been completed,
you must proceed with
JOINING THE
ENDS OF THE ROPES
, which must be done
at the last tarpaulin bow,
whether it is a single bow or the
single bow or double bow
rear flap bow.
The ropes must be joined
with care,
PRE-TENSIONING
them by hand, paying
special attention not to twist or damage them,
even before having finished assembling them.
The clamps must be positioned in the quantity of
two in the
back
at the last bow and
one in the front
at the last bow
.
To improve the stability of the pulling bow and to better house and keep the rope union at the support on the plastic
runner of the last bow
, you must also insert a metal bracket, as shown in the figure, which fulfils these
functions.
N.B
.
IF YOU USE AN ELECTRIC OR PNEUMATIC SCREWDRIVER TO TIGHTEN THE SCREWS,
YOU MUST ABSOLUTELY TIGHTEN THE LAST PART OF THE THREAD BY HAND
ATTENTION
:
Before completely tightening the terminals,
manually tension the rope as much as possible
.
ROPE-LOCKING CLAMPS
ROPE-LOCKING CLAMP DETAIL
1
) Last sliding bow
2
) FRONT rope-locking clamp with nuts
facing the outside of the container
3
) REAR rope-locking clamps with nuts facing the outside
of the container
Once you have JOINED
the ropes,
