CABRIOLE’
CRAMARO TS S.r.l. – 37044 COLOGNA V.TA (VR) - VIA QUARI DESTRA, 71/G TEL. +39 0442/411688 / FAX + 39 0442/411690
E-MAIL [email protected] WEBSITE: http://www.cramaro.com -
Manual n° MCA016-EN-ED00 – date 15/01/15
page
28
FIG 39
vc
CC
P
P
P
FIG 38
Carefully CHECK
the linearity of the upper container profiles; they must not show significant deformations,
protruding elements or hooks or, even worse, uneven levels that do not allow the bows to slide cleanly over the
entire length of the container.
In the front area where the rope pulling system will be applied, there must not be elements that make it difficult
to align and secure the unit supports.
Otherwise, you must remove or level the parts that do not allow the unit to be assembled properly.
ASSEMBLY ON RAISED CAB-SHIELD
Should the cab-shield be higher than the side edges,
you must proceed in one of two possible ways:
1
-
REMOVE THE RAISED CAB-SHIELD
and replace it with a
FLAT CAB-SHIELD
that allows for the
pulling system to be applied in such a position as to permit the tarpaulin to slide over the entire length of the
container, but ESPECIALLY to FULLY RETRACT on the cab-shield WITHOUT OCCUPYING PART OF THE
OPENING INTENDED FOR LOADING
Option 1
- when the front unit clearance
DOES NOT EXCEED 2040mm FROM THE CENTRE OF THE
SLEWING PIN
