CABRIOLE’
CRAMARO TS S.r.l. – 37044 COLOGNA V.TA (VR) - VIA QUARI DESTRA, 71/G TEL. +39 0442/411688 / FAX + 39 0442/411690
E-MAIL [email protected] WEBSITE: http://www.cramaro.com -
Manual n° MCA016-EN-ED00 – date 15/01/15
page
60
FIG 96
FIG 95
60 Cm
In
OPENING,
the action of
two TORSION SPRINGS
positioned on the sides of the last bow, allows the section of the
sheet covering the door to be lifted immediately. In
CLOSURE,
instead, the action of two
small CHAINS
anchored on
one side
to the side arms of the flap itself
and, on the other,
to
the next to last tarpaulin bow
, allows
the arms to lower just as quickly and, therefore, the
part of the sheet covering the door to
close.
To adjust, do the same thing
as for the double bow flap, that is,
ADJUST lowering by changing
the length of the chain anchoring
the arms to the next to last tarpaulin bow
- FINISHING AND PRE-USE CHECK OPERATIONS -
Once all the operations shown on the previous pages have been completed, you must calibrate some components
and then make sure that the entire system works properly.
FOR MANUAL AND ELECTRIC VERSIONS
Make sure the tarpaulin slides
, open and closed, without particular effort or sticking in its movement.
If the tarpaulin tends to get stuck and/or go across on the edges, it means that the
RH
and
LH pulling ropes do not
have the same tension;
as such, you must use the rope tensioners until you obtain equal tension on both ropes.
N.B.
Proper rope tension is adjusted
by opening the tarpaulin slightly (about 50-60cm)
and then using the specific tensioners
(FRONT or REAR) until,
when movement is activated, the ropes
slide
on the front pulling pulleys
without slipping
.
Do not tension the ropes excessively since,
in addition to causing sudden wear of the ropes themselves,
bow sliding does not improve but rather,
is more difficult.
Make sure that the
QUICK FIT HOOKS
freely go in and come out of the specific anchors located on the sides of the
container
PRE-FORMING RETRACTED SHEET
Fully retract the tarpaulin and make sure that
near the ends of every single
bow, the sheet has taken the proper form
(
strip pre-forming
); if necessary,
manually fix the most critical points and leave the
tarpaulin retracted for some hours.
With the tarpaulin fully extended, apply
the
additional safety anchors
to the quick fit hooks, distributing
them along
the entire length of the tarpaulin
